Wood density and fiber dimensions of Gmelina arborea in fast growth trees in Costa Rica: relation to the growth rate
Abstract
The objective of this research was to determine growth rate effects measured in tree diameter on wood density parameters (mean, minimum, maximum and intra-ring variation) and in fiber dimensions (wall thickness, fiber width, lumen diameter and fiber length) of trees from fast growth plantations. Thirty mature trees were sampled from thirty different fast-growth plantations with a wide growth rate in Costa Rica. A disc was cut from each tree at DBH. The wood density parameters and fiber dimensions were determined in each growth ring. Some wood density parameters and fiber dimensions were related with growth rate. The minimum and mean density, cell wall thickness, fiber width and lumen diameter decreased with increase in growth rate. Intra-ring wood density variation increased with growth rate but the weak correlation was established. Maximum wood density was not found correlation with growth rate. A pronounced decrease was presented in minimum and mean density from 0 to 20 mm/year and after to 45 mm/year. A pronounced decrease and increase with increase in growth rate were presented in the fiber length and intra-ring wood density, respectively. Lumen diameter and fiber width presented few variations, until 40 mm/year; however, they showed decrease after this growth rate value.Downloads
© CSIC. Manuscripts published in both the printed and online versions of this Journal are the property of Consejo Superior de Investigaciones Científicas, and quoting this source is a requirement for any partial or full reproduction.
All contents of this electronic edition, except where otherwise noted, are distributed under a “Creative Commons Attribution 4.0 International” (CC BY 4.0) License. You may read here the basic information and the legal text of the license. The indication of the CC BY 4.0 License must be expressly stated in this way when necessary.
Self-archiving in repositories, personal webpages or similar, of any version other than the published by the Editor, is not allowed.